- Update the connected dSS (e.g. dSS11-1GB) and then create a backup. If it is no longer possible to update the dSS or create a backup, you can download the last automatically created backup1 from the cloud. To do this, open the my.digitalSTROM portal on the Internet.
- Please open the my.digitalSTROM app on the configurator2 and disconnect your dSS from the logged-in account (log out).
- Switch off the current dSS (via circuit breaker) and disconnect the power supply.
- Disconnect/unplug the dS485 bus or the terminal block.
- Remove the dSS (and the corresponding power supply).
- Install the new dSS (e.g. dSS20) and connect the power supply. ! IMPORTANT ! Do not connect the dS485 bus yet!
- Combinations as follows require appropriate changes:
- dSS11-1GB server as a bridge and connected to the dSS11-IP: replace every device by a dSS20.
- Several dSS11-1GB connected as bridge plus the dSS11-IP: replace every dSS11 configured as bridge by the same number of dSS20 and configure one of them as master.
- Switch on the power respectively the dSS and wait approx. two minutes for the dSS to start up.
- Connect the dSS to your network and ensure that the dSS is given an IP address and access to the Internet3.
- Connect on your PC (with your browser) to the following address ("dss.local" 4) to open the configurator of the dSS.
- Open the system settings and update the dSS.
- After the update (and reloading the configurator), open the my.digitalSTROM app on the configurator2.
- Connect to a my.digitalSTROM account. Please note that the password of the digitalSTROM Server still needs to be changed. The new server is delivered with the default password.
- Then load the previously created backup onto the new dSS. If you are asked whether you want to restore the my.digitalSTROM account, click "no".
- Once the structure of the previous dSS has been restored, you can switch off the dSS and now connect the dS485 bus.
- Switch the dSS on again and wait until all devices have been read in correctly5.
- Now you can use the dSS again as usual.
- Automatic backup must be activated.
- To be found on the start page of the configurator (Apps section).
- Make sure that DHCP in your network is activated and no ports are blocked.
- Since some browsers and networks prevent/block name resolution („dss.local“ in an IP address), you might need to call the configurator by entering the IP address directly.
- Depending on installation size, this might take up to 30 minutes.